OD5 Conditioning Module
External PSU used, allows OD5 case to be smaller and isolates the mains voltage to make it safer
120Va.c. or 240Va.c. operation and suitable for use with all a.c. LVDTs and most others
Wide range span and zero control with both -10 to 10V and -20 to 20mA outputs
Gain and offset adjustment fully independent
Selectable transducer excitation frequency and load resistances
Forward and reverse connection selection, saves swapping wires in the connector
Housed in a robust die cast aluminium box with a 5-pin DIN connector
Half-bridge transducers accommodated with a simple plug wiring change
Power Supply
Mains Voltage
90 to 264Vac
AC Input Frequency
47 to 63Hz
AC Input Current
0.25A (120Vac), OI. 1A(250Vac)
Transducer Excitation
Transducer Drive
3V rms nominal at 2.5kHz (Lo) or 5kHz (Hi) nominal.
Rated 30mA max.
Transducer Signal Input
Sensitivity Range
400 to 2500mV (full range) (LVDT only)
Signal Output
Output Voltage Range
Up to ±10Vdc into 1KΩ min.
Output Residual Noise
>1mVrms
Output Current
Up to ±20mA into 150Ω load
Temp. Coefficient Gain/Offset
>0.1% full range/°C
Warm-up
15 minutes recommended
Linearity
>0.1% full range
Temperature Range
0°C to +50°C
IP Rating
IP40
Input/Output Protection
Short ciruit protected, transient and ESD protection
Mechanical & Connections
Tranducer
5-pin circular DIN
Power Supply Cable Length
1.8m max.
Mains Connector
IEC320 C14
Enclosure/Power Supply
120 x 65 x 40mm and 65 x 49 x 33mm
Certification
BS EN61000-6-2/3:2001;
EN60950: CSA22.2: UL1950
Supplied with
Instructions and 5-pin DIN plug.
Linear Variable Differential Transformers (LVDT)
These devices comprise a movable nickel iron core and three coils - one for energisation and two for pick-up. They need to be driven by a sine wave to produce an output amplitude and phase directly proportional to the position of the core with respect to the pick-up coils. A phase sensitive detector is ...
